- Out of Stock
Reference: T25CF002
Brand: Seas
T25CF002 - 25mm Soft dome Tweeter - Seas Excel Millennium - 6 ohm - E0011
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Diffuser in KIT Seas - ODIN MKIII |
The Odin Mk3 is a completely redesigned version of the famous Odin kit, which uses the latest drive unit technologies of the Excel product line. This kit uses two W18E001 woofers and a single "MILLENNIUM" T25CF002 tweeter mounted in D Appolito configuration for each cabinet.
The cabinet is a bass reflex design with the vent positioned at the rear. This directs any potential venting noise away from the listener and allows a minimum deflector area in the front. The pvc door tube is supported by an internal deflector which helps to maintain the same air flow on each end of the tube and also serves as additional bracing of the cabinet. The port tuning frequency is 31Hz.
The crossover network is conventional except for a parallel circuit that suppresses the peak response due to the magnesium cone. The crossover frequency is 2.5kHz. The Odin Mk3 was designed by Dr. Joseph D Appolito and was developed as an accompaniment kit to the Thor transmission system.
It offers the following comments regarding the Odin MK3 performance:
"The ventilated box is calibrated about 15% less than the ubiquitous QB3 alignment to provide a more subdued bass response. Several hundred hours of laboratory and listening tests have been incorporated into this system. You cannot literally know. where the woofers start and the tweeter starts ".
Parameters | Value |
Nominal impedance | 4 Ω |
Sensitivity 1W / 1m | 89 dB |
Frequency range | 33-25.000 Hz |
Crossover frequency | 2500 Hz |
Nominal power | 200 W |
Maximum power | 400 W |
Recommended amplification | 50-400 W |
Parametersi | Specificationspecifiche |
Volume Cabinet | 34 L |
Dimensions | 241 x 559 x 362 mm |
Way | n. 2 |
KIT contents - Odin MKIII |
4 x Woofer (W18E001) 2 x Tweeter (T25CF002) 2 x Inductor in air 1.00mH 1.6mm (BBA1601.000) 2 x Air inductor 0.15mH 0.8mm (BBA0800.150) 2 x Air inductor 0.25mH 0.8mm (BBA0800.250) 2 x MKP condenser 8.20µF 400V 5% axial (CP008.20) 2 x Condenser Z-Superior 8.20µF 800V 2% axial (CZP008.20) 2 x Condenser Z-Superior 15.0µF 800V 2% axial (CZP015.00) 2 x Condenser Z-Superior 3.30µF 800V 2% axial (CZP003.30) 2 x MKP condenser 2.20µF 400V 5% axial (CP002.20) 2 x MOX resistor 0.47ohm 10W 5% axial (RM10000.47) 2 x MOX resistor 2.20ohm 10W 5% axial (RM10002.20) 2 x MOX resistor 12.0ohm 10W 5% axial (RM10012.00) 2 x Polyester Damping Cloth Material - 2000x500x30mm (MFA00) 10 x OFC speaker cable 2x2.5mm² white sheath (CVS25C) 2 x Binding Post gold plated insulated 40mm (BP13) 2 x Audikom PCB for 17x22cm crossover filters (PCB02) 2 x Plastic tube Diam.68mm Length 220mm (PTD68L220) |
Dimensions and dimensions |
Electrical and Acoustic Measurements |
Reference: T25CF002
Brand: Seas
Reference: KIT BREZZA
Brand: Mike Borghese Audio
Reference: KIT SIMBIOSI
Brand: Mike Borghese Audio
Reference: KIT SORRISO
Brand: Mike Borghese Audio
Reference: KIT DUETTO
Brand: Mike Borghese Audio
Reference: KIT ECLISSI
Brand: Mike Borghese Audio
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent